Detecting a Slab Leak in Garland, Texas

Written by Steven Shipler, Texas Licensed Master Plumber, Responsible Master Plumber (RMP), MBA, and host of The 4 Guys Education on YouTube.

A slab leak in a Garland home is easy to miss until the damage is already done. A warm patch on the floor, an unexplained jump in the water bill, or a faint hiss of running water when nothing in the house is turned on are usually the only warning signs. Detecting the leak the right way means locating it precisely with acoustic and electronic equipment before anyone ever picks up a jackhammer.

What Is a Slab Leak?

A slab leak is a leak in the water or drain piping running beneath a home’s concrete foundation. Many Garland homes, particularly those built from the 1960s through the 1980s, route copper supply lines directly under or through that slab. When a pipe corrodes, rubs against rebar, or shifts as the ground moves, water begins escaping into the soil below or works its way up through the concrete itself.

Because the pipe is buried, you can’t see the leak directly. You only see the effects of it, which is exactly why the right detection equipment matters before anyone commits to a repair.

Signs of a Slab Leak in a Garland Home

• An unexplained increase in your water bill
• The sound of running water when every fixture is off
• A warm or hot spot on the floor, often over a hot water line leak
• Damp carpet, warped flooring, or a musty smell in one area
• Low water pressure at one or more fixtures
• Cracks in the slab or nearby walls
• A water meter that keeps spinning with everything off

How We Locate a Slab Leak

Locating a slab leak is a process of elimination, not a guess. We first confirm the leak is actually under the slab and not something more obvious, like an irrigation line or a water heater. Once that’s confirmed, we isolate which line is leaking and use listening and tracing equipment to narrow the location down to a specific spot before any concrete comes up.

Tools and Equipment Used for Slab Leak Detection

1. Acoustic leak detection listening equipment: A ground microphone and amplifier used to listen for the distinct sound of water escaping a pressurized line under concrete. That escaping water has a recognizable hiss that gets louder as you get closer to the source.
2. Electronic line tracing equipment: A transmitter and receiver used to trace the path of the water line itself, so we know exactly where the pipe runs before narrowing in on the leak location.
3. Infrared thermal imaging camera: Especially useful on hot water line leaks, since heat rising through the slab often shows up as a distinct thermal signature before it’s ever visible to the eye.

Why Garland Homes Are Prone to Slab Leaks

Garland sits on the same expansive clay soil found across most of North Texas and Dallas County. That soil swells when wet and shrinks when dry, and the foundation moves slightly with it season to season. Many Garland homes were built decades ago with copper supply lines poured directly into or under the slab, and that older copper is now well into the age range where corrosion and rub-through leaks become common.

Nearby Dallas neighborhoods on similar soil see the same pattern, and Richardson’s mix of older and newer construction shows both age-related pinhole leaks and settlement-related leaks depending on when a given home was built. The soil is the constant across North Texas. The age and construction of the home determine how soon it becomes a problem.

Slab Leak Detection vs. Guessing

What Happens After the Leak Is Located

Once the leak is located, there are usually a few repair paths worth comparing: a spot repair that opens a small section of slab directly over the leak, a reroute that runs a new line through the attic or around the slab entirely, or, in some cases, repiping the whole home if the existing copper is old enough that more leaks are likely soon. The right answer depends on the pipe material, age, and how the leak was found, all of which gets documented in your Master Plumber Report.

Watch: Leak Detection and Underground Diagnostics

City Reference: Garland Area

A dedicated Garland map is not yet available, so the Dallas County area map below is shown as the closest regional reference.

Reference Section: Plumbing Code Topics

Slab leak repair should be evaluated with attention to water distribution sizing, pipe protection, and testing requirements. Always verify the current adopted code edition and local amendments with your city’s building department before repair work begins.

What Our Customers Say

Schedule Online

Pick your slab leak detection appointment time below.

Helpful Internal Links

• The Ultimate Guide to Sewer Inspections Before Buying a Home
• What Can a Sewer Camera Inspection Find?
• Sewer Inspection Checklist for Home Buyers
• Testimonials
• Contact Us

Frequently Asked Questions (FAQs)